1. Basin faucet and kitchen faucet have small water output and no foaming
Possible cause: the bubbler cannot produce bubbles due to low water pressure.
Solution: remove the faucet and replace it with a new bubbler.
2. Water leakage at the connection between hose and faucet
Possible causes: improper installation, deformation of rubber ring, uneven or too thin outlet pipe joint, or mismatch between hose and faucet.
Solution: select the appropriate hose and faucet according to the specifications, replace the rubber ring and reinstall it.
3. Low water temperature
Possible cause: the power of water heater is insufficient and the temperature is not adjusted in place.
Solution: adjust the temperature control button or buy a water heater with large water output.
Shower maintenance skills
1. Experienced professionals shall be invited for construction and installation. During installation, the shower shall not collide with hard objects as far as possible, and do not leave cement and glue on the surface, so as not to damage the gloss of the surface coating. Pay special attention to remove the sundries in the pipe before installation, otherwise the shower will be blocked by the sundries in the pipe, which will affect the use.
2. When the water pressure is not lower than 0.02MPa (i.e. 0.2kgf/cm3), if the water output decreases or even the water heater stalls after using for a period of time, gently unscrew the screen cover at the water outlet of the shower to remove impurities, which can generally be restored as before. However, remember not to forcibly disassemble the shower. Due to the complex internal structure of the shower, non professional forcible disassembly will lead to the failure of restoring the original shower.
3. Do not use too much force when opening and closing the shower faucet and adjusting the water outlet mode of the shower, and turn it gently according to the trend. Even the traditional faucet does not need to spend a lot of effort. Pay special attention not to support or use the faucet handle and shower support as handrails.
4. The metal hose of the shower head of the bathtub shall be kept in a natural stretch state, and it shall not be coiled on the faucet when not in use. At the same time, pay attention not to form a dead angle at the joint between the hose and the faucet, so as not to break or damage the hose.